Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Meridian CS1000 Capacity Report - LD Command? 1

Status
Not open for further replies.

kjb2601

Technical User
Dec 6, 2006
8
GB
I know you can run a command which lists the number of Digital, analogue, IP etc..... services equipped and used.

Can someone please confirm what the command is?

also is there anywhere I can download a list of the various LD commands and what they are used for?

Thanks

 
Have you tried out this link for the LD commands


I usually go into LD 117 and key in INV GEN SETS and also INV GEN CARDS.

Wait for the task to complete (could be 10 minutes) and then key in INV PRT SETS or INV PRT CARDS etc

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

If it's working, then leave it alone!.
 
LD 22 REQ SLT
gets you what they are licensed for.
LD 117
actually takes an inventory of all the sets with part numbers
LD 81
REQ: CNT
FEAT: sets
Gives you a count of all the different kinds of phones programmed.
REQ: LST
Will list all of them in TN order.

LD 22
REQ:pRT
Type: pkg
Tells the packages enabled.
REQ: ISS
Gives the software release
 
this list may be a little out of date...

LD 1 Template audit
LD 2 Traffic
LD 10 Analog (500/2500) Telephone Administration
LD 11 Digital Telephone Administration
LD 12 Attendant Consoles
LD 13 Digitone Receivers,Tone Detectors, Multifrequency Senders and Receivers
LD 14 Trunk Data Block
LD 15 Customer Data Block
LD 15 Data Block: AML (Application Module Link)
LD 15 Data Block: ANI (Automatic Number Identification)
LD 15 Data Block: ATT (Attendant Consoles)
LD 15 Data Block: AWU (Automatic Wake Up Data)
LD 15 Data Block: CAS (Centralized Attendant Service Data)
LD 15 Data Block: CCS (Controlled Class of Service)
LD 15 Data Block: CDR (Call Detail Recording)
LD 15 Data Block: FCR (Flexible Code Restriction)
LD 15 Data Block: FFC (Flexible Feature Codes)
LD 15 Data Block: FTR (Features and options)
LD 15 Data Block: HSP (Hospitality Management)
LD 15 Data Block: ICP (Intercept Computer Update)
LD 15 Data Block: IMS (Integrated Message Service)
LD 15 Data Block: INT (Intercept Treatments)
LD 15 Data Block: LDN (Listed Directory Numbers)
LD 15 Data Block: MON (Set-based Monitoring)
LD 15 Data Block: MPO (Multi-Party Operations)
LD 15 Data Block: NET (Networking)
LD 15 Data Block: NIT (Night Service)
LD 15 Data Block: OAS (Off Hook Alarm Security)
LD 15 Data Block: PPM (Periodic Pulse Metering)
LD 15 Data Block: PWD (Password)
LD 15 Data Block: RDR (Call Redirection)
LD 15 Data Block: ROA (Recorded Overflow Announcement)
LD 15 Data Block: TIM (Timers)
LD 15 Data Block: TST (Test lines)
LD 16 Route Data Block, Automatic Trunk Maintenance
LD 17 Configuration Record 1
LD 17 Data Block: ADAN (Input/output devices -includes D-channels)
LD 17 Data Block: ALARM (Alarm filter configuration data)
LD 17 Data Block: ATRN (Aries Transmission)
LD 17 Data Block: CEQU (Common Equipment parameters)
LD 17 Data Block: CFN (Configuration data block)
LD 17 Data Block: OVLY (Overlay area options)
LD 17 Data Block: PARM (System Parameters)
LD 17 Data Block: PWD (System Password and Limited Access)
LD 17 Data Block: VAS (Value Added Server)
LD 18 Speed/Group Call, Pretranslation, Special Service
LD 19 Code Restriction
LD 20 Print Routine 1
LD 21 Print Routine 2
LD 22 Print Routine 3
LD 23 Automatic Call Distribution, Management Reports, Message Center
LD 24 Direct Inward System Access
LD 25 Move Data Blocks
LD 26 Group Do Not Disturb
LD 27 ISDN Basic Rate Interface (BRI) Administration
LD 28 Route Selection for Automatic Number Identification
LD 29 Memory Management
LD 30 Network and Signaling Diagnostic
LD 31 Telephone and Attendant Console Diagnostic
LD 32 Network and Peripheral Equipment Diagnostic
LD 33 Peripheral Equipment Diagnostic for 1.5 Mb/s RPE and Fiber Remote IPE
LD 34 Tone and Digit Switch and Digitone Receiver Diagnostic
LD 36 Trunk Diagnostic
LD 37 Input/Output Diagnostic
LD 38 Conference Circuit Diagnostic
LD 39 Intergroup Switch and System Clock Generator Diagnostic
LD 40 Call Detail Recording Diagnostic
LD 42 Call Detail Recording Diagnostic
LD 43 Equipment Datadump
LD 44 Software Audit
LD 45 Background Signaling and Switching Diagnostic
LD 46 Multifrequency Sender Diagnostic for Automatic Number Identification
LD 48 Link Diagnostic
LD 49 New Flexible Code Restriction and Incoming Digit Conversion
LD 50 Call Park and Modular Telephone Relocation
LD 51 Intercept Computer Update
LD 52 2.0 Mb/s Remote Peripheral Equipment
LD 53 2.0 Mb/s Remote Peripheral Equipment Diagnostic
LD 54 Multifrequency Signaling Diagnostic
LD 56 Flexible Tones and Cadences
LD 57 Flexible Feature Codes
LD 58 Radio Paging
LD 60 Digital Trunk Interface and Primary Rate Interface Diagnostic
LD 61 Message Waiting Lamps Reset
LD 62 1.5 Mb/s Remote Peripheral Equipment Local End Diagnostic
LD 66 Conversion
LD 73 Digital Trunk Interface
LD 74 Digital Private Network Signaling System Link
LD 75 Digital Trunk Maintenance
LD 77 Manual Print
LD 79 Virtual Network Service
LD 80 Call Trace
LD 81 Features and Station Print
LD 82 Print Hunt Chain, Multiple Appearance Group
LD 83 Terminal Number Sort and Print
LD 84 Set Designation Entry (DES ODAS)
LD 85 Set Designation Entry (DES ODAS)
LD 86 Electronic Switched Network 1
LD 87 Electronic Switched Network 2
LD 88 Authorization Code
LD 90 Electronic Switched Network 3
LD 92 Automatic Trunk Maintenance
LD 93 Multi-Tenant Service
LD 94 Multifrequency Signaling
LD 95 Call Party Name Display
LD 96 D-channel Diagnostic
LD 97 Configuration Record 2
LD 117 Ethernet and Alarm Management
LD 135 Core Common Equipment Diagnostic
LD 137 Core Input/Output Diagnostic
LD 143 Customer Configuration Backup and Restore
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top