Meridian Cisco link errors

[Mandog]

We have a Meridian CS1000M connected to CUCM 8. When you make a call from a Cisco to Meridian & vice versa we get an error on the Meridian.
PRI5033 DCH:25 Data:4
The link is set up as QSIG

Meridian message breakdown
Meridian Error Message PRI5033 DCH: 25 Data: 4
Severity: Critical
An application has requested to send on a QSIG a non-call related
message received on MCDN but the QSIG RCAP is not configured on the
outgoing link or the service is not supported on QSIG. The message is
rejected.
Output: DCH or DSL number, PRI/BRIT type, Service identifier. The
following service identifiers are defined:
4. Network Message Center

Because it is critical in nature was my conecrn.

Any ideas?

 

[CaseFile]

What are the RCAP settings on your DCH ?
I have COLP NDI CCBI CCNI PRI DVSI CTI QMWI.