meridian bri problem

[stratplayer10]

I have an issue with BRI on a rlse 22.46 site.
Config is standard and agrees with otrher working sites.
when I connect to the port the status goes to layer 2 established but the port does not process the call at all.
The status of the port remains at established after terminating the call, unless you physically disconnect.
The Misp is in slot 3, Silc in slot 9.
I have tried all ports on the card and also changed the Misp and Silc, and reloaded the Misp also.
Any thought folks??

 

[mikeyb123]

bad driver in bri modem?

It's not getting any smarter out there. You have to come to terms with stupidity, and make it work for you.

 

[stratplayer10]

I dont belive it to be a terminal issue as the same status exists on several types, I suspect M1 problems, the config has been re checked with a working site, and concurs, thanks

 

[mikeyb123]

have you a bri tester? this should give some more info if all the configs match

It's not getting any smarter out there. You have to come to terms with stupidity, and make it work for you.

 

[stratplayer10]

The channels tested fine with a BRI tester The solution here in the end was nothing to do with the M1 config at all, the connections were to a Video Conferancing suite, and the configuration of the BRI DN's did not match what was already configured in the Vid Conf kit, once corrected all was well. Important...All channels have to have the matching DN numbering on both M1 & VC

Stratplayer 10

 

[mikeyb123]

happy days....

It's not getting any smarter out there. You have to come to terms with stupidity, and make it work for you.