MD110 LCR WITH TWO COSTUMER

[clockwave]

Hello,

I have two route on my MD110 route 11(analogue) and route 60(ISDN/PRI) I programmed an LCR on the system.

My problem is, I have two sets of extension distinguish by CUST what I want is all outgoing call from extension with CUST 1 (extention 1102) should take the PRI or route 60 and the other extension without CUST (7112) should take route 11 as as first choice for local call and second choice would be route 60 at the same time all NDD and IDD call from 7112 should go to route 60. Is there a work around on this? Below is my configuration. Please advice.


Thanks,


Oliver


<EXDDPIR=ALL;
EXTENSION DIRECTORY DATA
DIR CUST EQU CAT TYPE ICAT AUX
1102 1 001-0-22-01 2 EL6 0040
7112 001-1-60-11 2 EL6 0000


DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
1911 11 000500000000025000000000 0 5 0
60 1 022500000000025000200110 0 5 0
1960 60 022500000000025000200110 0 5 0
60 1 022500000000025000200110 0 5 0

<LCDDP:TAB=FDT;
LEAST COST DESTINATION DATA
FICTITIOUS DESTINATION TABLE
FRCT TZONE PRE
11 1 1911
60 1 1960


<LCDDP:TAB=DNT2; /* PARTIAL PRINT-OUT ONLY FOR DNT2
LEAST COST DESTINATION DATA
NUMBER TABLE
ENTRY TRC PRE ACCT FRCT TOLL CBCS BTON TNS OSA
900 1 0 60 111111111111111 0
901 1 0 60 111111111111111 0
91 1 0 11 111111111111111 0
92 1 0 11 111111111111111 0

<LCLDI:LIM=1,AC=1,DEST=1911;
EXECUTED

<LCLDI:LIM=2,AC=1,DEST=1911;
EXECUTED

 

[PetrNik]

Hello,

RODDIEST=1911,ROU=11...(no CUST)
RODDIEST=1911,ROU=60,CHO=1...(no CUST)
RODDIEST=1911,CUST=1,ROU=60...

RODDIEST=1960,ROU=60...(no CUST)
RODDIEST=1960,CUST=1,ROU=60...