MD to Cisco E1 Qsig

[aastratech]

can anyone help with the following;
We have connected a MD BC12 to a Cisco callmanager 2821 with E1 Qsig.

The customer wants to dial the extn number only to ring the Cisco phones but everytime we try this,see print for 1120 we recieve dial tone back and then have to dial again the extn number. I have created a temp dest code 5 and this works ok ie dial 51120 and the extn 1120 on cisco rings.
Below are a copy of prints.Route 2 is the Qsig link
Appreciate any help on this

<ROCAP:ROU=2;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
2 7110000000000010 5 3110030000 0 30 128 03151515 111110000031 111111

RODAP:ROU=2;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
2 SL60 H'00000310 H'55440000 H'06400000 NO

<RODDPEST=1120;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
1120 2 1505100000000250105001001 0 1 0

<RODDPEST=1120;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
5 2 1505100000000250105001001 0 1 0

 

[thedayaftertomorrow]

Hi mdevo,
<ROCAP:ROU=81;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
81 7110000000000010 5 2110000010 0 30 128 00151515 111101100031 001100

<RODAP:ROU=81;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
81 SL60 H'00000210 H'054A0000 H'06300000 NO

<RODDPEST=84;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
50 81 1636100000000250105001001 0 1 0
this parameters is working

best regards

 

[aastratech]

thanks for your response,
as always Cisco guys were saying they had configured the router properly but after we put some pressure on them as we knew the problem was 99% always going to be them they made some changes and HEY presto ! it worked...
cheers for the info though. Wont tell us what they changed though..

 

[madaza]

Help please
My PBX BC9 LIM 1 connect to the CISCO router with TLU 76/1 but after SCEXI i got alarm 65 synchronisation faulty inf1 4
addinf3 1.
Thanks

 

[aau2]

Try to change the varo to 06000000.