Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

mcis.......upgrade from 4.1

Status
Not open for further replies.

Wolfpack28358

Programmer
May 13, 2011
5
US
I have a MCIS software ver. 4.1 and need to upgrade to keep PRI routes from dropping when system looses power. Question is: When I power down system and change to new software, will I loose all programming? If so how do I save all programming?
 
You only need to swap out the NVRAM (outer portion of the s/w assembly)to correct that problem. This was a known issue with the Rls 01 NVRAMs.
Document your System ID number. (F**SYSID)
Perform a backup first, power down and swap the NVRAM, power up.
Restore from backup.
Confirm your Sys ID. If it changed, you'll need to regenerate your PRI Enabler keycode.

-SD-
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top