McData 6064 configuration

[tuka]

Trying to setup a new McDATA 6064 and can't comunicate with the maintenance port (DB-9) located on the backside of the 6064.

Tried these settings:
V100 terminal
115200 baud, 8 data, 1 start/stop bit, no flow control
used modem cable and a crossover (null modem) cable

Reduced baud down to 4800 while using both cables and can't
get any response at the terminal.

Tried using a laptop and internet browser to default IPaddress of 10.1.1.10 but no response. I think the IPaddress has been set to some other address so that is the reason I am going thru the serial port.

Is there other settings?

 

[Novelli]

Best idea will be, connect pc with ethereal installed, look ast the packages and you will see which ip address is used

Cheers Novelli
Novell Master CNE + CDE

http://www.eckertweb.de