Which Maxspeed board? There are 5 multiport models that I am aware of.
Most terminals and printers can be configured to use XON/XOFF protocols, thereby making cabling a bit(sic) easier. This is also known as software handshaking. Certain Okidata printers need to be configured to ignore hardware handshaking signals or they will still use them even when set to XON/XOFF protocol.
DB25 to DB25 is typically pins 2-3, 3-2, 7-7. It also helps to carry a null-modem in case the above doesn't work, if both devices are DTC or DCE, then pins 2-2, 3-3, 7-7 usually does it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.