Max TNT setup

[lafnboy]

Hi,

I have gone completely brain dead setting up a replacement TNT system. Everything is working except I cannot get incoming calls to route to the Internet.

I know I am missing the obvious, but I am tired and need a break.

Any setup gurus that can tell me what I am missing?

Thanks

 

[LucentGuy]

Are you assigning IP's from a pool? If so then is your TNT on the same logical subnet as your IP pool? If so then you need to have proxy-mode=active. This parameter can be found by reading the IP-interface applicable. For the shelf controller it is read ip-inter {{1 17 1}}.

Likewise, if your TNT is not on the same logical subnet as your IP pools then proxy-mode should be off.

Hope this helps.

 

[lafnboy]

Perfect answer. Sorry I wasn't clear, but you covered the scenario.

proxy-mode=active was the answer.

We are IPs from a pool and the TNT is on the same logical subnet.

Thanks for the response.