Masking INBOUND caller ID (CLI) from a specific cell phone caller to any ICR DID

[telfire]

I have looked over several earlier posts on this and have not seen anything recently, so thought I would start a new post. At this point my mind is mush and hoping for a fresh set of brains.
This is IP500v2A R11.1.3.1 with a PRI and VMPro on the AppSvr. I started with the Incoming Call Route (LGID is that of PRI channels, Incoming number is a *, CLI is the inbound cell phone caller, and made a tag "Anonymous Caller", Destination is "." I also saw that might be able to force the call back out using a short code NS"Anonymous Caller" and then right back in using a 3rd call path - seems stupid they would want this but they have 46 call paths and only have this feature request for 2 cell phones. They might be open for sending it to a VMPro module as well, getting a IVR to tell them to enter the extension they want to call and then have it blocked there... just spit balling. I hate to give more context as this customer is migrating from Aura CM and they had the feature (call masking) on that, but for those asking why they want that. For those same people that ask why, please dont say they should have stayed on the CM - they will survive if I cant give them this, but wanted to see what type of "work around" I could implement. Thanks Ya'll

APSS-Midmarket
ACIS-Midmarket
ACSS-Midmarket
ACDS-Midmarket

 

[Westi]

I don't know of any good way to hide (mask) the caller ID on the IPO

but maybe you have some analog line ports and analog extension ports then you can turn off the caller ID on the line ports and loop it back into the system on the lines.



Joe
FHandw, ACSS, ACIS

https://www.millsidetc.com/