MAS 90 3.71 Forms

[computerlady143]

I had to reinstall MAS 90 to the d: drive due to room on c: drive. I copied over the directory that has the reports. Yet when we go to print a Sales Order it just sees the standard report. I haven't installed Crystal Reports yet. But I thought you could use the form and only Needed Crystal if you made changes. Bottom line how do I get my forms seen. I though you went to the forms code when you go to print the Sales Order???

 

[dfeller]

Did you copy the ENTIRE mas90 directory over to the D:\ drive? You should not have needed to reinstall.

Dawn

Visit Sage's Online Community

http://community.sagemas.com/sagemas/?category.id=SageMAS90and200Disc

 

[computerlady143]

I installed it new for several reasons. One data and program were on two different drives, which I know it can work that way and has for a couple of years. But I had to move the program to the D drive due to no room on C: So at this point I just need to get my Invoices and Sales Order forms over. I had the instructions from Sage but it wasn't created the form in the correct place. Possible I didn't have the right knowledge base answer. So, since I not going to undo the work I did, I just need to find out how to copy the forms from the old data.