Manual Running Totals don't like "Repeat Headers"? 2

[dianemarie]

When I do manual running totals using variables, I always have an issue when I "Repeat Group Header On Each Page". It starts the count over if the group gets continued onto the next page and the group header repeats. This is very annoying, because a lot of my reports are large and become hard to use without the repeated headers. Anyone have a fix or work-around for this? Or is it something that has to be lived with. Thank you very much.

 

[lyanch]

There is a built in boolean that will tell you when you are in a repeated header. You just need to do something like:

if not InRepeatedGroupHeader then
calculate


Lisa

 

[hhiebert]

Lisa, you're my new hero! I've been looking for this solution all my life [slight exaggeration]. hh...