Manual Cloning Tries Another Volume

[Iago77]

Hello again,

well, I hope someboy help me again, thanks in advance...

I'm trying cloning save set manually. I select save set and I backup them in a CloneOS volume (label is an example). First I select all save sets of each original volume, to prevent Legato uses several clone volumes.

My problem is the next one: For example the clone volume contains the first cloning selection, it's ok, but then, when I select all save sets which are in other volume, Legato tries to uses another clone volume, instead of using the first one whose size is about 100GB and it only contains 13GB from first original volume.

I'm sorry, but I'm Spanish and my English level is basic.

Many thanks in advance, again

 

[speculos]

Hello Iago77

why do you select the savesets of each original volume separately? Try to select all you want to clone, and then all the data will be written to the same clone volume (until it becomes full)

(my English level is basic too, excuse me but I'm French...)

 

[Iago77]

Because in that case, Legato tries to get other volumes. That's the reason because I've had to do this proccess. In fact, If I proceed in this way I can get all save sets in the same volume.

 

[605]

Hard to understand you guys ;-)

NW in fact could write to multiple clone media, but this is a bit more complicated and does not only depend on which save sets you selected.