SheffieldDave
IS-IT--Management
Is there a possibility to assign a management address for the Netbuilder II?
(Like the Cisco loopback interface)
All routers in our NMC are modeled by the IP Address of the first LAN port.
If this LAN port goes down (switch failure,...) the NMC notifies a malfunction of the whole Netbuilder.
But if there were an own management address, we could model the Netbuilder by this address.
Thanks for your time
(Like the Cisco loopback interface)
All routers in our NMC are modeled by the IP Address of the first LAN port.
If this LAN port goes down (switch failure,...) the NMC notifies a malfunction of the whole Netbuilder.
But if there were an own management address, we could model the Netbuilder by this address.
Thanks for your time