Hi all,
I have a serious problem on my hands right now and I need all the help I can get.
I have two offices, one with a BP250 PBX and the other with a MD110 (BC12) and everyone uses authority code to make calls at both ends. I have set up E&M voice networking between them and our users can all call each other on their extensions. That is fine.
The problem is that Mgt does not want to buy separate CO trunks at the BP250 office. They want the users there to make their calls through the MD110 office. I have programmed the routers for this destination pattern but all I get after dialing my digits from the BP250 end is a continuous dial tone. I do a debug and see that the router at the MD110 end is actually seeing the call coming in.
Can anyone tell me what the problem might be? I actually think it's on the MD110 PBX.
Thanks guys for your responses.
I have a serious problem on my hands right now and I need all the help I can get.
I have two offices, one with a BP250 PBX and the other with a MD110 (BC12) and everyone uses authority code to make calls at both ends. I have set up E&M voice networking between them and our users can all call each other on their extensions. That is fine.
The problem is that Mgt does not want to buy separate CO trunks at the BP250 office. They want the users there to make their calls through the MD110 office. I have programmed the routers for this destination pattern but all I get after dialing my digits from the BP250 end is a continuous dial tone. I do a debug and see that the router at the MD110 end is actually seeing the call coming in.
Can anyone tell me what the problem might be? I actually think it's on the MD110 PBX.
Thanks guys for your responses.