Andrewiski
Technical User
How can I assign a T/R so it only uses a specific pool? I want the T/R to use pool 70, the analog lines when it dials out instead of pool 800 as the new PRI voip circuit doesn't support data calls.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Magix T/R Line Outbound Pool
- Thread starter Andrewiski
- Start date
- Status
TouchToneTommy
Vendor
You can assign pool 70 to a "button" on the extension through WinSPM, set it to NO ring, and change the Auto Line Select to grab that first. You also now don't have to dial a 9 to go out.
You could change the FRL of the extension, and build a new route in ARS, with the matching FRL and 70 as the pool dial out code.
You could give the extension Pool Dial Out access to 70, and have it dial 70 instead of 9. Be sure to pause after the 70, to allow the line to connect and receive dial tone.
You could change the FRL of the extension, and build a new route in ARS, with the matching FRL and 70 as the pool dial out code.
You could give the extension Pool Dial Out access to 70, and have it dial 70 instead of 9. Be sure to pause after the 70, to allow the line to connect and receive dial tone.
- Status
Similar threads
- Locked
- Question