I'm trying to re-program the park zone buttons on a 4424LD+ on the console extension 100 using Quick access in WinSPM (it was wiped out when I tried to add a line appearance button in the personal lines, in quick access in WinSPM.) When I select park zone, then choose zone 881 when prompted, and click apply, the system gives me a programming error [20].
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Magix button programming error [20]
- Thread starter tgross
- Start date
- Thread starter
- #3
- Thread starter
- #5
It is not. However, something strange happened when I originally added the line appearance. This phone had 11 lines in 2 different trunk pools assigned to it and they were assigned sequentially to the buttons from bottom to top from left to right before I added the single additional line. When I added the line it re-arranged the pools and skipped the top 2 buttons on the left side columns. It is still doing this.
One other piece of info, there's a 4450 DSS attached to this phone.
One other piece of info, there's a 4450 DSS attached to this phone.
- Thread starter
- #8
- Thread starter
- #11
Thanks for the help on this. I was able to program the buttons through central programming. I have never used that option because it doesn't recognize the top row of buttons on the 4424 and I was not sure what effect it would have on the programming.
TouchToneTommy
Vendor
In Centralized Programming, press the button for "Page 2", then the top row of buttons for the 4412 and 4424 phones are 21, 23, 25, and 27.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question