I just droped in a 4.0 processor, and cannot change mode of operation to H/pbx, it will select behind sw mode ?. i removed all cards and went in via spm, did a system erase and board renumber, but did not help. Has anyone had this issue, am i missing somthing or do i have a bad processor. Any info would be greatly appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
magix 4.0 processor 1
- Thread starter KCPHONE
- Start date
-
1
- #2
- Thread starter
- #3
Thanks Merlinman, after i posted i reviewed all the way back to sept 04 and found an upgrade post that had the info i was looking for, had i known you would reply so quickly i would have just kicked back and watched the news. yes it was the dip switches, i never have had to change them and i have installed bunches of magix, maybe ive been lucky
- Status
Similar threads
- Locked
- Question
- Locked
- Question