Magix 3.0 PRI W/100 DID # how do I froward a number to a ext. 1

[rsurin]

Magix 3.0 PRI W/100 DID # how do I froward a number to a ext. There will be five numbers that are going to port over to the PRI how do I asign the Number to an Ext?

 

[Naperguy1]

What you are going to do is go to:

Lines and Trunks > PRI > Incoming Routing

This is a table where you can set up DIDs to route where you want them to go. You only have 15 patterns and 1 is reserved for your DIDs (Usually Pattern 0).

Take Pattern 1 for example:

Service Any Service
Pattern to match 1234 (What did are you rtg)
Expected Digits 4 (How many digits sent)
Digits to delete 4
Digits to add 5678 (Where to go)

That is if you have DIDs that are not in your dial plan. Otherwise, you can renumber an extension to match the DID coming down the PRI. Let me know if this helps.

Naperguy1

 

[pdaddy0820]

Is there anyway to print out the incoming routing patterns through SPM to see what is currently programmed in the switch?

 

[Naperguy1]

If you go to:

Print
PRI

This pulls up the entire PRI programming. At the bottom of the page, you will the the heading "Dial Plan Routing Table"

This gives you what digits are coming in and where they are being routed if you are manipulating digits on your end. Note: there are only 15 patterns you can manipulate.

naperguy1

 

[merlinman]

Actually, there are 16 patterns....

0 thru 15

Old Western Electric numbering I guess.....