I've recently been switched from Macola to GP 10. In Macola there was a gross requirements report had an interface that allowed you to enter several bom p/n's and quantities desired. After entering this information Macola would compute what parts are short based on the sum total parts from the bom's entered, parts on hand, and parts allocated. Is there a similar tool in GP 10?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Macola Gross Requirements Alternative in GP 10
- Thread starter punchback
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question