I have a M2250 console that intermittently can not complete the digits when dialing an outside number. The digits dialed will stop at “1-np” for long distance or “”nx” for local calls. I have changed consoles, cross connect, feeder pairs on the IDF and changed TN’s. The system produces this error code:
% NCT400 44 0 5 3 BUSY LOC:44
% 00BD707E 00BD689A 0156A77F 0A6043A2 0155F2D9
% NCT400 + 015931F1 01592D15 01592C6F 015908BB 01590809
% NCT400 + 00C74CC5 00C714D9 00C71096 01D1A170 01D12EB5
% NCT400 + 0122479C
%
% TIM475 13:00 20/6/2013 CPU 1
%
% DTC001
%
%
% NCT400 44 0 5 3 OVF
% 00BD57E9 00BD530F 0156E00E 0156C537 0A60440B
% NCT400 + 0155F2D9 015931F1 01592D15 01592C6F 015908BB
% NCT400 + 01590809 00C74CC5 00C714D9 00C71096 01D1A170
% NCT400 + 01D12EB5 0122479C
The system is an Option81c in release 5 Succession software. It is patched current. The TN is on a TALC card manufactured by Telstrat Corporation. According to there specifications the M2250 is supported. All calls route on Pri’s. Any suggestions ?
RKDavis Wilmington,NC
