A friend gave me an m100 and it appears the batteries have been dead. Retrieving data is not an issue. With good batteries I've performed a soft, warm and hard reboots. After hard reboot and erasing all, it starts through the calibration but goes into an endless loop. If I turn it off and back on I get the main screen but nothing operates properly, probably because the screen is not calibrated, etc??? Any suggestions? I'm not too familiar with these things...
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Andrzejek on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
m100 messed up
- Thread starter scottmbow
- Start date
FelixTheCat
IS-IT--Management
something looks definetely (physically) broken.
like the screen "sensor". it sure doesn't look like anything software...
like the screen "sensor". it sure doesn't look like anything software...
- Status
Similar threads
- Locked
- Question