Lucent Serial/Parallel Adapter 1363110 Settings?

[hdingman]

Anybody have the DIP switch settings for a Lucent 1363110 Serial-to-Centronics adapter?

I've had no luck finding them.
12-pin DIP.
I assume it's for baud/parity/stop maybe xon/xoff or RTS/CTS.

4,096 combinations, and only 1 is right...

:-(

Thanks

Howard Dingman
Pro-Tel Communications
Endicott, NY

webmaster<at>holocom<dot>com

 

[hdingman]

Still looking . . . Anybody can help? ? ?

Thanks again.

Howard

 

[edfair]

Probably time for you to open it up and see where the switches connect. Should be a UART inside and most of the switches end up connecting to it. Unless it is late enough that the die is buried in some other package.
Nothing on the Lucent site that remotely resembles it. So maybe it is a OEMd product.
I would suspect that it will be more that just a serial to centronics because that can be rather restricted. Maybe serial to parallel and 1 switch of the 12 to convert it to parallel to serial.
This could be an interesting project to get working, but comparable stuff sells on the market for under $100 so you may not want to waste too much time.

Ed Fair
Any advice I give is my best judgement based on my interpretation of the facts you supply. Help increase my knowledge by providing some feedback, good or bad, on any advice I have given.