We have two E1 lines. The Old E1 line is assigned at CBQ.1 and the new E1 line at CBQ.2 My concern now is the output? where do I configure the output? Our existing(old) was configure at CBQ.5(eth.1). Do I assigned also at CBQ.5 the output of the new E1? Or I will assigned it at CBQ.6(eth.2)? My purpose is to load balance.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
LUCENT AP 1500 Balance Loading
- Thread starter Kentwifi
- Start date
Similar threads
- Locked
- Question
- Locked
- Question