Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

LTER and ZDP

Status
Not open for further replies.

teekow

Vendor
Nov 23, 2003
427
US
I am trying to use ZDP to send certain calls back to the trunks at my CS1000B and certain calls to stay at the main office. For the calls that stay at the main office, I want to use LTER: YES on the RLB. This works if I manually dial AC1 (9)+SPN (109) + number but does not work if the SPN is being inserted automatically by ZDP. Example, 9+109+1-NPA-NXX-YYYY goes thru just fine at the main office but if I enable ZBR for my zone and dial 9+1+NPA-NXX-YYYY, I get reorder with no err message. It is hard to paste that table due to formatting, but the zbr is enabled for my zone and my "DC1" is 109 and the "Dialed AC" is AC1 in the table. 109 is built as an SPN.

The calls I need sent to my local CS1000B trunks including 911 calls complete fine at the remote site. I just can't get local terminate to work when ZDP is involved at the main office.

Thanks
Rob
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top