<REQUESTPIN Module - "That PIN is invalid"

[Mullet_Rocker]

Trying to make use of built in module for Conference in IPO/VMPRO 10.1. Defined PIN under User tab. Pointed short code to <REQUESTPIN. Dial short code and get greeting....enter PIN defined on User tab....and it states, "That PIN is invalid".

What am I doing wrong? Is this not a pre-configured flow to work with the User tab PIN and transfer into a bridge?

 

[intrigrant]

Bfore invoking the module you must save a correct PIN in a variable, either CP1 or CP2.
Look in the requestpin module

 

[Mullet_Rocker]

>REQUESTPIN Module has the following tokens
1. Menu_Enter_Conf_Pin --> with two options TIMEOUT and $. $ continues on to CP1
2. SetCP1 (Generic Token) --> Set CPxx Value, Select Data Variable: CP1, With Value: $KEY. That has a NEXT that points to CP3
3. SetCP3 (Generic Token) --> Set CPxx Value, Select Data Variable: CP3, With Value: PIN=$KEY. This has a NEXT that points to Variable Test Token
4. CheckScConfPin (Test Variable Token) --> Select the Variable to Match: $TAG, Select the parameters(s) to test the variable against: Variable: $CP3

Under the section SELECT THE PARAMETER(S) TO TEST THE VARIABLE AGAINST: I have the option of specific, Extn, Hunt Group and Mailbox. The above is the default config.

Not sure where I can save a PIN for CP1 or CP3 first.