Hi Chaps,
I have got a server where lpstat upon a printq shows me the status of the queue as Paused. This server actually spools the jobs to a lpd daemon running on NT server, so I was suspecting it is due to the lpd daemon on NT would have been paused. But I am not very sure about this. Also I have never seen this status when lpstat was run.
If I have to restart a specific queue I understand I have to use qadm or smitty qstart or enq command, but is there any cmd which can refresh the queue rather than stopping and starting explicitly.
TIA
Kumar
I have got a server where lpstat upon a printq shows me the status of the queue as Paused. This server actually spools the jobs to a lpd daemon running on NT server, so I was suspecting it is due to the lpd daemon on NT would have been paused. But I am not very sure about this. Also I have never seen this status when lpstat was run.
If I have to restart a specific queue I understand I have to use qadm or smitty qstart or enq command, but is there any cmd which can refresh the queue rather than stopping and starting explicitly.
TIA
Kumar