lpfc firmware upgrade causes Luhns to Disappear

[DavePnP]

Solaris 8. SunV480

After updating my HBA (LP9002Le) firmware to Ve. 3.93a0, all of my disks show up as "drive type unknown"

Powerpath shows everything as great, all paths working, alive, no errors. But I am getting scsi messages saying the disks are offline, and this is the kicker:

# vxdmpadm listctlr all
CTLR-NAME ENCLR-TYPE STATE ENCLR-NAME
=====================================================
c1 Disk ENABLED Disk
c4 OTHER_DISKS ENABLED EMC_CX400

My lpfc controllers don't show up at all there, and c4...that's a usb flash drive, not my CX400.

 

[DavePnP]

UPDATE:
c4 is not a usb flash drive, however there are no disks on c4 on the system. All disks are on c2 and c3, both which do not appear whend the cntrl's are listed.

 

[DavePnP]

UPDATE2: It was a driver upgrade that caused the problem not the firmware upgrade. Drivers were upgraded from 5.01e to 6.10g. Did the same procedure on a sister box with no problem.