Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Lost ALOM Password 1

Status
Not open for further replies.

vgman

Technical User
Jun 5, 2008
1
US
I have a netra 240 that is stuck at the please login ALOM prompt. The original owner had changed the password and he does not remember it. I have already tried admin and admin1 for the password and nothing. Does anyone have any ideas.

Thank you
 
Search this forum for ALOM, I'm sure there have been a few threads on this subject.

Annihilannic.
 
if the machine is not up and running, thus the reason you need to get into the alom to start the console, the easiest thing to do is remove the alom card. By removing the card and doing a reboot, it will activate regular console properties within the OBP. By default the alom ask for a passwd, even when one has never been set. you said it has at one time though.

If you are able to get into the server, then you just have to download the RSC pkg and install and configure to get the ALOM working. reboot is required to activate it.

get it from: I think it is called 'remote system control'

I think I have the exact procedure at work, just going from memory now.


David
 
you asked about reseting the passwd, here is the commands to add another user with full privs.


/usr/platform/`uname -i`/rsc/rscadm useradd
/usr/platform/`uname -i`/rsc/rscadm userperm cuar
/usr/platform/`uname -i`/rsc/rscadm userpassword



these commands will do it,
 
1. power down
remove power cords for several seconds

2. press esc key during alom boot when this is on screen:
Boot Sector FLASH CRC Test
Boot Sector FLASH CRC Test, PASSED.
Return to Boot Monitor for Handshake

After esc key is pressed you get the ALOM Menu

3. Enter e to erase the ALOM NVRAM
4. Enter r to return to ALOM boot process
 
How to bypass ALOM password on a Sun Fire V210/V240/V250/V440


To overide the ALOM password on the system you will need to:

1) Attach console to Serial Management Port

2) Power on the server via the front power button. Once POST has completed, you will need to wait 1 to 2 minutes for a timeout to occur and the system to drop to the "ok>" prompt.
If you do not get the "Please login:" prompt (you will likely see the SC prompt) then you must power the system off remove the battery from the LOM board, wait a minute, and re-install everything).

* Below is an example of what you might see on the console:

Please login:
SC Alert: Host System has Reset

[wait one two minutes]
Serial line login timeout, returns to console stream.

ok>

3) Boot the system to the OS level. If Solaris is not currently installed on the server, you will need to install it at this point.

4) Use the scadm command to reset the admin password:

1. cd /usr/platform/`uname -i`/sbin
2. ./scadm userpassword admin

5) Use the escape sequence "#." to get system back to the alom login prompt.

1. You can now log into the admin account using the password from step 4 b).
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top