loss of telnet 8600 ?? 2

[mucka]

hi guys ,recently upgraded our 10 8600,s to ver 3.2.2.2 .
Since then on only 3 of them we cannot telnet to.
If we reset to 2nd blade ,then we can telnet ,but not to original cpu.

any help please ??

mucka

 

[eurobadger]

Sounds like you may have set the defaults on the CPUs where telnet does not work during the upgrade.

Telnet is enabled by turning on the 'telnetd' flag. This can be access through the flags command in the Boot Monitor CLI.

Have a look in the document 'Reference for the Accelar 8000 SeriesCommand Line Interface Switching Operations' on

http://www.nortelnetworks.com.

 

[ZachBenj]

Sounds like telnet not turned on in the boot.cfg file on tha blade. here is an example of a boot.cfg with telnet, FTP and TFTP turned on.

flags ftpd true
flags telnetd true
flags tftpd true
choice primary image-file "/flash/p80a3121.img"
choice secondary config-file "/pcmcia/config.cfg"
choice secondary image-file "/pcmcia/p80a3121.img"

Hope this helps.

My suggestions are what I would try myself. If incorrect, I welcome corrections to my knowledge.
Scott
stomlin@baptistfirst.org

 

[mucka]

thanks guys, this did the trick.tek-tips works well eh!!

mucka.