Loss of MWI light on Resiliency Failover

[mitelmitel]

Is this supposed to happen?

When sys A fails over to sys B the MWI disappears, even when it fails back.

Nupoint, 3300 R8.

 

[LoopyLou]

You would loose the MWI failover becuase the systems don't update each other on MWI status. If the system crash is the cause of the failover, I don't believe MWI status would be retained.

 

[TheMitelGuy]

One fail-back (not fail-over) you can either wait until re-org takes place at night, or there is a command to force the resyncing in the NP.

 

[mitelmitel]

They are saying that when fail back occurs the MWI light does not return.

 

[LoopyLou]

It would not return until the next refresh. Again I don't think the status of message waiting lights would be preserved if the 3300 reset.

 

[mitelmitel]

I just checked the resiliency guidelines there is no mention about the MWI re-appering on the Primary after failback.



How do you configure the MWI refresh?

Remember I am using NuPoint not embedded.

 

[mitelmitel]

What I mean to say is how to you configure the automatic refresh?

I know how to do the manual refresh.

Thanks