Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Loss of drill up/down behavior for custom sets (using unions)

Status
Not open for further replies.

RyanDonohue

Technical User
Jun 10, 2011
18
US
Hello All,

I am pretty new to Cognos, but have been having fun creating reports with custom sets using unions for items in the same hierarchy level until I realized this causes the issue of losing the ability to drill up or down. Is there anyway to enable drilling up/down for these sets? I tried looking into member sets and overriding the hierarchy, but was unable to get this to work. For clarity, I have documented an example below. I appreciate your help.

For example, I have the data below in the hierarchy displayed.

A
1
a
b
2
a
b
3
a
b
B
1
a
2
a

I have a group of A1 and A3 called Group A. On my report, I display Group A. How can I enable a drill down so I can see A1a, A1b, A3a, and A3b?

Please let me know if I have not been clear and I will do my best to clarify. Thanks.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top