Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
losing Groups on ipoffice 1
- Thread starter High Mesa
- Start date
A defective SD card.
IP Office remote service
IP Office certificate check
CLI based call blocking
SCN fallback over PSTN
IP Office remote service
IP Office certificate check
CLI based call blocking
SCN fallback over PSTN
Its been a while, but I remember there being an issue where groups would disappear if the IPO was configured as a DHCP client on LAN 1.
If your system is set as a DHCP client on LAN 1, set a static address, reboot and that should take care of it, or use LAN2/WAN if DHCP is the only option.
If your system is set as a DHCP client on LAN 1, set a static address, reboot and that should take care of it, or use LAN2/WAN if DHCP is the only option.
- Thread starter
- #4
-
1
- #5
biv343 nailed it 100% sure you have the LAN port set to be a DHCP client(its set this way by default and should always be changed). If you have the LAN port set to be DHCP client, and the IP changes, your groups disappear. This has been around since I got involved with IPO and will likely be there till the end.
If you happen to know what the IP use to be if you change the IPO to that IP the groups will actually come back just a FYI.
The truth is just an excuse for lack of imagination.
If you happen to know what the IP use to be if you change the IPO to that IP the groups will actually come back just a FYI.
The truth is just an excuse for lack of imagination.
- Status
