Hi,
Has anybody tried configuring a looped H.323 trunk in MX-ONE?
I have configured an H.323 route with the same parameters I use when connecting two separate MX-ONE systems (IP networking).
In RODDI, I use DEST=900, SRT=4, IP=own_ip_address, then I try calling 900105 (where 105 is a free extension) but the call isn't established and I get a timeout. When checking with SUSIP, only one of my H.323 trunks gets busy and I don't get an incoming call on the route.
Any ideas?
Has anybody tried configuring a looped H.323 trunk in MX-ONE?
I have configured an H.323 route with the same parameters I use when connecting two separate MX-ONE systems (IP networking).
In RODDI, I use DEST=900, SRT=4, IP=own_ip_address, then I try calling 900105 (where 105 is a free extension) but the call isn't established and I get a timeout. When checking with SUSIP, only one of my H.323 trunks gets busy and I don't get an incoming call on the route.
Any ideas?