Loop-start trunking

[SenorAvayaGuy]

Hello all,
I currently did a configure for a phone system and cant seem to dial out from my CO trunk. I currently have 8 POTS lines connected.
The call seems to be routing correctly but gives me a steady busy. Here is a trace of the call (In California dialing to Seattle).
Route pattern 7 is our "unlimited calling" and COR on the phone is correct. Please advise,

Thank you !

15:21:22 active station 1111 cid 0x13d
15:21:27 dial 91206330 routeREFIX|FNPA|ARS
15:21:27 term trunk-group 1 cid 0x13d
15:21:27 dial 91206330 routeREFIX|FNPA|ARS
15:21:27 route-pattern 7 preference 1 location 1/ALL cid 0x13d
15:21:27 seize trunk-group 1 member 1 cid 0x13d
15:21:30 dial 912063304960 routeREFIX|FNPA|ARS
15:21:30 outpulse done 12063304960
15:21:40 active trunk-group 1 member 1 cid 0x13d
15:21:43 idle station 1111 cid 0x13d

 

[AvayaTier3]

use a test set on each loop start line and dial 1 + area code + 7 digits and see if you get a busy from the provider



A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]

 

[joe2938]

Also make sure you signed up for a long distance provider on these trunks

 

[SenorAvayaGuy]

Figured the resolution out, it was a "duh" moment.

The POTS lines were actually lines off another PBX.
Went through route patterns and entered a 9 in inserted digits so that way there's a double 9 for their PBX as well (in not so technical terms)
figured id post resolution for anyone who is new to the system.
thank you to all who replied.