LOOP NOT RE-ESTABLISHING on CS1L

[norteldiva]

Hi All:

We had a power surge last night and one of my PRI's is showing as disabled. I have been unable to get it back on line. Here is what I am seeing in STAT for Loop 20:

PRI* TRK LOOP 20 - DSBL
FFMT/LCMT/YALMT: ESF/B8Z/FDL

I have tried ENLL 20 and all I receive is DTI216 20.

Can you provide me with some assistance? I appreciate your time!

 

[bhassell2000]

Sounds like it doesnt see the card, can you stat or reseat the card?

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[KCFLHRC]

Is this a TMDI Card? If so go into LD 96 and do a RST TMDI Loop# Shelf# Card#

 

[DFKSydney]

DTI0216
There is no response from the card.
Check for the existence of the card and try again.
Severity: Minor


Looking like a failed card.

 

[KCFLHRC]

I have seen this same issue before and was able to get the card to respond with the RST command

 

[monkey101]

if it is a UDT card make sure you are at the latest firmware...I was having that issue and latest firmware cleared it up.

 

[Tman45]

Yeah we just had a MGC fail because I had to power down the system. If it doens't work after reseating or doing the RST like KCFLHRC recommends then I would say it is toast