Log Repair Action

[Mag0007]

Hi All,

I had an ensloure problem last month. Now, I got the problem "fixed", IBM was on site, and replaced the part. Therefore, I did a Log Repair Action (diag->Task Selection(Diagnostics, Advanced Diagnostics, Service Aids, etc.)->Log Repair Action-><<selected my resource>>)

Now when I press 'commit' (F7) I get a '*'

I am not sure what I do next...do I just exit out?

TIA

 

[DukeSSD]

Yeah, the * means that resource has been actioned upon.

It is the same when running diagnostics to a resource, afterwards the resource selection is redisplayed and the previously tested rerources have a * against them.

To check the repair action was logged look in the errpt for an error: 2F3E09A4 REPLACED_FRU logged against the resource in question.