locations table only allowing 1 entry

[wwmarcww]

S8300D with a fresh install of CM 6.3 with SP8 installed. The locations table is only allowing 1 entry. Doesn't even have the 250 possible entries available. system is fully licensed and license mode is normal. Anyone ever come across this one before? Been a while since I did an install, I don't remember having to adjust the amount of available location entries anywhere....

 

[AvayaTier3]

Command: display system-parameters customer-options

page 5 Multiple Locations? n

license needed to change to "y"

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]

 

[montyzummer]

To elaborate you need to log into the smi of the cm goto the licencing section and activate multiple locations and save and exit if you are on cm6.3 you can do this as this is one of the features included in the 6.x upgrade procedure

APSS (SME)
ACSS (SME)
ACIS (UC)

 

[bleebrant]

Also on 6.3 with multiple locations you may no longer see the locations table as before since the capacity has gone up to 2000 from 250.
You can add a location number, and list locations to see all locations programmed.