Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Location-based Calling for X-ported Stations

Status
Not open for further replies.

cycledick

Technical User
Oct 6, 2005
141
US
S8720/CM5.0 - All TDM stations in G650s

I've got two locations built. Calls come in on a PRI in Location 2s G650 (the "cabinet" is in location 2) to an x-ported station that has remote coverage to an outside number. My ARS is built for location 1 and location 2. The "all" table is empty.

The problem is that calls to x-ported stations don't seem to have a location. If I leave it x-ported, I get an error that says "No ARS/AAR route pattern". If I assign a port that is in location 2 to the station, it follows location 2's ARS. If I put my dialed string in the ARS "all" table, it follow the "all" table.

So, how do I get x-ported stations to follow location-specific ARS WITHOUT using the partition-route-index table and seperate CORs with a different time-of-day chart?

Thanks in advance!
 
Telecommuting and Remote Call Forwarding both use the ARS All table.

As a side note, if these associates are never in the office you should be using virtual stations vs. x-ported stations. That way you don't eat up your RTU.

Kevin
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top