LJ 2100 Paper Curl

[Bacardi412]

I've replaced a few different Fusers and still no luck. Would this be an Engine controller board problem or do you think I had bad luck with the fusers I've tried. I dont remember how thick the paper was or if they changed type of paper. Any suggestions would be helpful.

 

[netmanrick]

Have you tried "fanning" the media before putting it in the paper tray?????
Is the paper of good quality??? Ie: 20 lb stock,not as thin as tissue paper.
Is the paper stored in close proximity to printer,or in some
unconditioned storeroom??
Lots of probabilities.I used to carry a quantity of quality paper just to test these conditions.

Rick Harris
SC Dept of Motor Vehicles
Network Operations