klabaza
MIS
- Aug 3, 2005
- 59
Hi people.
Hope this questions goes here.
I have 2 Linx data terminals, they are old, OS IV or V, the problem is that i need to change the IP, i have been googling around but didnt find anything that help me, i check the site but no info about, the only info i found say that if i want to change the IP i need to unplug the terminal, before turn on need to Press ENTER+F1 key, i try a lot of times bad no answer, but didnt say nothing about for wich terminal...?
My terminal has this keys:
F1 1 2 3 CLEAR
F2 4 5 6 <-
F3 7 8 9 EXIT
F4 IN 0 OUT ENTER
Did someone knows how to change the IP of the Linx data terminal like this one...?
Or some docs or sites that could help me...?
Any info a will apreciated, greetings.
Hope this questions goes here.
I have 2 Linx data terminals, they are old, OS IV or V, the problem is that i need to change the IP, i have been googling around but didnt find anything that help me, i check the site but no info about, the only info i found say that if i want to change the IP i need to unplug the terminal, before turn on need to Press ENTER+F1 key, i try a lot of times bad no answer, but didnt say nothing about for wich terminal...?
My terminal has this keys:
F1 1 2 3 CLEAR
F2 4 5 6 <-
F3 7 8 9 EXIT
F4 IN 0 OUT ENTER
Did someone knows how to change the IP of the Linx data terminal like this one...?
Or some docs or sites that could help me...?
Any info a will apreciated, greetings.
