gatorch0mp
Programmer
I have the following setup:
Office
---------------------------
DSL Modem: Netopia
VPN Router: Linksys RV082
Home
---------------------------
Wireless Router: NetGear
VPN Client: Greenbow
RV082 <--> Netopia <--> **Internet** <--> NetGear <--> Greenbow Client
I configured the RV082 and Greenbow client to the exact specifications outlined in the Greenbow PDF. When I "Open Tunnel" on the client, the RV082 shows that "IPSec Tunnel Connected". However, I can't ping any unit on the remote LAN. I haven't configured any sort of NAT-T because I didn't see any instructions saying to do so. The Greenbow client displays a green LED and the message indicating an open tunnel. The client log doesn't display any error messages as well.
Where could I have possibly gone wrong? Let me know if I need to provide any additional information.
Regards,
Randy
Office
---------------------------
DSL Modem: Netopia
VPN Router: Linksys RV082
Home
---------------------------
Wireless Router: NetGear
VPN Client: Greenbow
RV082 <--> Netopia <--> **Internet** <--> NetGear <--> Greenbow Client
I configured the RV082 and Greenbow client to the exact specifications outlined in the Greenbow PDF. When I "Open Tunnel" on the client, the RV082 shows that "IPSec Tunnel Connected". However, I can't ping any unit on the remote LAN. I haven't configured any sort of NAT-T because I didn't see any instructions saying to do so. The Greenbow client displays a green LED and the message indicating an open tunnel. The client log doesn't display any error messages as well.
Where could I have possibly gone wrong? Let me know if I need to provide any additional information.
Regards,
Randy