linksys rv082 and firebox 1000 problems

[TobyHynes]

All,
I dont know if this is he correct forum for my issue but here it goes.

Issue: installing linksys rv082 with minimal lan reconfiguration behind a already configured firebox.

company "A" has a T1 pluged into a watchguard firebox that has been configured to the hilt with static routes forwarding,etc. Also 1 DSL line that has been unused for
1 year, I have 5 public static address for each line.

so I have my A records, mx records pointed at .197 address which is configured on the firebox wan side, then the firebox nats the addresses to a 192.168.1.x and forwards the smtp,citrix,web,http ports to the correct servers.

I have been asked to install this rv082 unit behind the firebox, and also plug in the DSL into wan2 port for failover. If there is anybody out there that I can roll a few questions at, it would be greatly appreciated.

-Toby Hynes

 

[bcastner]

http://www.broadbandreports.com/forum/equip,16

Start by doing a search on existing threads.

I warn you that you may be unhappy with the current state of affairs with the firmware of this device.