I need help. I cannot get my linksys nc100 v.2 card to work. Im
running dragonlinux with what appears to be the latest tulip driver
v.095 which fails with device busy on boot. PNP is disabled. ifconfig
shows lo but no etho. The adapter shows irq 10 with I/O oxd800
[oxd801]. It does not appesr to have any conflics. I have been
screwing with this for three days and do not know what to try. Since I
have the latest tulip version I have not tried to compile a new one. I
would like someone to walk me through troubleshooting this problem.
Thanks in advance.
running dragonlinux with what appears to be the latest tulip driver
v.095 which fails with device busy on boot. PNP is disabled. ifconfig
shows lo but no etho. The adapter shows irq 10 with I/O oxd800
[oxd801]. It does not appesr to have any conflics. I have been
screwing with this for three days and do not know what to try. Since I
have the latest tulip version I have not tried to compile a new one. I
would like someone to walk me through troubleshooting this problem.
Thanks in advance.