link between smartnode 49xx & Cisco CUCM 9.1 using SIP

[youfo007]

hi,


I want to configure a 49xx SmartNode Fxs to link with CUCM 9.1 using SIP.

for that, thank you for giving me the config CUCM and Smartnode.

thank you

 

[whykap]

All you would need to do in cucm is configure a sip trunk to the channel bank and then configure route patterns pointing to that trunk.
As far as the 4900 I've never configured one. You would need to read their install guide for sip integration.

 

[youfo007]

first thank you for the support.

config for the SmartNode 49xx, I found something on the net.

the idea is to take advantage of such a gateway Fxs end to connect remote users more than 100 meters.

our CUCM was a prefix 8 x x x x.

the question, how is going to affect this numbering plan to FXs.


Thanks

 

[whykap]

No different than any other gateway. You'd point the DN's for the FXS ports to the sip gateway.
You'll have to see this as having two separate systems, it will require call routing from both ends to get it working. Again though, no different than any other sip integration.
Have you considered running fiber to that remote connection, installing a POE switch and giving users IP phones?
If that's not an option for you for some reason, have you considered and cisco FXS gateway instead? It might save you some trouble.

 

[youfo007]

I know that there are solutions such as CISCO-CISCO VG224, but I try to find the solution for the sake of research.

for the fiber and the switch is not so simple, because it was an industrial facility.