Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Lines on MICS hang and you can't get a line out

Status
Not open for further replies.

murphymouse

IS-IT--Management
Oct 2, 2007
23
CA
The lines even show up on some sets with black deltas showing in use...they are not though
 
Most likely locked up by voice mail or failed conference or redirect.

Reboot system or pull line jumpers off the harness and re punch down.

Make sure Disconnect Supervision is set to YES in each line and that the Telco observes this as well.

 
Heavy emphasis on Disconnect Supervision...

If it is set correctly, make SURE the telco has got it enabled on the lines, too. We had a customer using Vonage voip lines, and they told us they couldn't send DS.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top