My lines on my CM6 will lockout and not go idle on its own. If our tech is on the frame doing verification, he sometime will short the pair and lock out the port. The only way to release it is to go into the system and release it. Is it possible to setup some kind of routine maintenance testing on the system?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Line testing thresholds
- Thread starter jlroeder
- Start date
dialtonebone
Technical User
What type of "lines" are you talking about?
- Thread starter
- #3
dialtonebone
Technical User
Are they stations? Trunks?
Could you post the config for these devices?
How do you release it from the system? Busy/release?
Could you post the config for these devices?
How do you release it from the system? Busy/release?
- Status
Similar threads
- Locked
- Question