Line Disconnect and Dialogic

[rmgt]

I am trying to get dialogic to understand the line disconnect signal from an analog line, I configured the CLS of the analog extensions to have LDTA, when I do the PBXpert on dialogic, it does detec the disconnect, but when I do a test, it fails!

Any help?

 

[johnpoole]

line current drops to 0 for around 40 seconds, after a timed delay, both are flexable. changing then will alter hook flash timers. have them publish what the need, and post that, maybe someone has that setup. i can't help a lot with those timers, not being at work to check the switch. if you can deny hook flash for those ext, dialogic may see the disco. to find the exact timing, connect a miliamp meter in SERIES with ine side of the line. one thing i have learned about dialogic, let's just say they need a division that is named not very logical at all.

john poole
bellsouth business
columbia,sc

 

[rmgt]

The problem is that I need the flash to transfer... so I can't win... !!

I found it in the manual there is a timer for it on LD 15, but I couldn't figure out how to change the current value

2-(6)-3
?

 

[johnpoole]

find out what they need for a flash timer for transfer, and see if they can modify the two params so it works for their box and is still usable, a few mili second difference will not work for most users. they need to make their flash shorter and their disco longer. they you can adjust yours. ld 15
chg
tim

john poole
bellsouth business
columbia,sc