Limit call duration Openscape / hipath 4000

[Hamid2018]

Dears
Hi,
Could you please tell me how to limit call duration for an specific subscriber number (even analogue, digital , HFA or even SIP).

for example we have a control room witch there should be no limitation for its calls but we have some public out door kiosk telephones which should be able for call through Trunks but we need them not to be busy more than 10 minutes, I should say that we ran billing and CDR (Call Detail Recording) but we exactly need the calls be dropped in 10 minutes for some extensions (some of them are analogue and some are Digital and some are IP-phones...

 

[Moriendi]

From V6 software there is a feature "Restricted Call Duration for Transit Calls". With COT parameter CDSV, TDCSU timers WARNTIM and CALLTIM are used to apply a warning tone and then disconnect.

It only works for transit calls (unless you find a very useful bug).

An outgoing call from 4K extension to CO is not a transit call. So you would need to make every call from the kiosk phones a transit call by using prefix dialling or LCR to route around a back to back trunk before reaching the CO trunk. On the incoming back to back, you could activate this feature.

 

[sbcsu]

As far as I remember Call duration can be limited by using the PERSI AMO
Change one of the PERSI programs to allow a short duration call only
Assign a PIN code to a phone for that PERSI type

 

[adibv]

@ sbcsu:
I assume you are thinking about PINDUR param in PERSI: COPIN
Not sure if it works, never tested.

CHANGE-PERSI:TYPE=COPIN,COPIN=...,PINDUR=TIME;

PERM - PIN is permanently active
PIN can only be deleted manually after entering a specific code.

TIME - PIN is deactivated after timeout.
PIN can only be deleted manual or after timeout (the time can be set using the AMO CTIME (CP1) parameters PINVO1 and PINNV1 (e.g. 1 for COPIN).
PINVO1 - Validation of PIN for COPIN1 (VOICE)
PINNV1 - Validation of PIN for COPIN1 (NON VOICE)

ONE - PIN activated for 1 call