LIM Module - CO trunk Routing

[kwbMitel]

I am posting this question as a reality check. I believe very stongly that I know the answer, but you never know anything 100% in my book.

Does anyone know of a method whereby you can route a CO trunk that is connected to a LIM module on a users TW set to that users Mailbox.

System type = 3300 SW version recent
Voicemail = Embedded
Trunk type on 3300 = PRI

To decrease responses: I already know how to call forward the CO line using Telco Forwarding to a DID on the 3300 and route that into the users MB.

Any others?

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.

 

[nytalkin]

Nope. The LIM shows as an appliance connected to the set but there is no conectivity to the network.

NO GOOD DEED GOES UNPUNISHED!

 

[LoopyLou]

Agree the LIM is a seperate entity. I assume the teleworker is at a site where there is no 3300. Otherwise you could point the trunk at an ONS port and forward that to voicemail.

 

[kwbMitel]

No more responses required.

This was a reality check exercise.

Thanks Loopylou and nytalkin. Your answers have always been trustworthy by my observation.

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.